Viking Repair Bellevue, WA (425) 696-2636

Refrigeration · Bellevue

Viking Refrigerator Buzzing or Clicking Every Few Minutes

Two very different noises get described the same way on the phone. A short buzz on a steady rhythm is usually an ice maker calling for water that never arrives, and it is harmless. A click from the machinery while the cabinet slowly warms is a compressor trying to start and giving up, and that one will not wait. Viking Repair Bellevue, (425) 696-2636.

A small geared motor assembly on a counter towel beside two nut drivers, two screwdrivers, two pairs of pliers and a wire brush

What we usually find

  1. Most often

    The ice maker's water valve. Viking notes that it buzzes as the ice maker tries to fill whether or not a water line is connected, so a closed or missing supply keeps it calling.

  2. Sometimes

    A fan catching on frost, or a cover rattling as the fan spins up. The ice around it usually traces back to a defrost fault, and a scraping edge to the sound gives it away.

  3. Rarely

    The compressor clicking on and straight off again without settling into a run. Cooling fades over the following hours, and it needs a technician before the food warms.

Sorting the sound

A buzz that lasts a few seconds and repeats at intervals, loudest near the freezer, belongs to the ice maker trying to fill. It carries on until water arrives or the arm goes up, and it does no harm while it waits.

A single click from the machinery compartment, a short hum and another click, with no steady running in between, is a compressor that cannot get going. On most refrigerators a protective device cuts the power each time it fails to turn over, then lets it try again a few minutes later, which is where the rhythm comes from.

A tick or scrape that begins as a fan starts and stops when it stops points at ice around the blade, and so at the defrost behind it.

What happens next

A buzzing ice maker is settled by restoring its water or leaving it switched off. A compressor that will not start is traced through its start parts and its power before anything larger is considered, so a click does not automatically mean a big repair.

Safe checks before you call

  1. Compare it with Viking's normal sounds

    Viking lists rushing air from the fans, gurgles and pops from refrigerant, sizzling from the defrost heater and a high hum or pulse from the compressor. Stone and tall cabinetry make all of them seem louder.

  2. Quiet the ice maker if there is no water

    If the unit has no water line, or the supply is off, raise the ice maker arm until it clicks. Viking gives this as the way to stop the buzz.

  3. Confirm it is still cooling

    Put a thermometer on a middle shelf and feel whether the freezer is as hard as usual. A noise with steady temperatures is rarely urgent.

  4. Find where it comes from

    Listen at the grille, at the back wall inside and in the freezer. The place, and whether the sound keeps time with the ice maker, narrows it down before anyone arrives.

  5. Stop and hand it over

    If none of that changes what the Viking is doing, leave it there and ring Viking Repair Bellevue on (425) 696-2636. Tell us what you already tried; it narrows the visit before we set out.

Asked about this

  • Is a Viking that gurgles, pops or hisses broken?

    Not on its own. Viking describes gurgling or boiling-water sounds as refrigerant moving through the system, and sizzles, hisses or pops as the defrost heater at work. Those come and go with normal running. A regular click with the cabinet warming is the sound to act on. Viking Repair Bellevue sorts one from the other on (425) 696-2636.

Next step

Tell us the symptom. We will tell you what it usually is.

Say what the appliance is doing and what you have already tried. Most calls are narrowed to one or two likely faults before anyone sets out.

Technicians go out 8:00 am – 8:00 pm, seven days; the (425) 696-2636 line itself is staffed 24/7.

Nut drivers, screwdrivers and pliers on a cloth with a paintbrush, a pulley, a coil spring and two stamped cam plates